KAWASAKI ZRX1200 男子汉用后感(更新在50页) 加入照片游记迟些再补上各位先消化照片吧

super_white

原帖由 大黄蜂805 于 18-5-2009 02:05 AM 发表
kent记得等迈我，我们一起下sepang。。。。

esplanade 排第14，Sepang 要排第几？

kent26

原帖由 大黄蜂805 于 18-5-2009 02:05 AM 发表
kent记得等迈我，我们一起下sepang。。。。

老兄那天看到你在前面怎样过湾我都看到了～不是你对手啦！！！

kent26

原帖由 人造人间 于 17-5-2009 10:41 PM 发表
哗，Kent兄昨天槟城一日游，今天金马伦啊？

谢谢分享！

月尾去泰国～节目很多～要来吗？

stephycool

原帖由 kent26 于 18-5-2009 10:27 PM 发表


月尾去泰国～节目很多～要来吗？

cubzai去泰国，
到达目的地时，
车散人跨，
PP开花！

kelvinlowlcy354

原帖由 stephycool 于 18-5-2009 10:43 PM 发表


cubzai去泰国，
到达目的地时，
车散人跨，
PP开花！

有心就不会有这借口，125z跑到kl,5小时45分钟，里程大约430km又怎样说？何况penang去huozai才

大约2百多公里出一些而已。

原帖由 kent26 于 18-5-2009 10:27 PM 发表


月尾去泰国～节目很多～要来吗？

几号过去？我在最高元首诞辰那天可能过去huozai，你的时间是？算了，还是不敢加入你们

神将都要你们等了，我的天 。。。。。你们去泰国哪里？节目是？看人妖？？

原帖由 kent26 于 18-5-2009 10:26 PM 发表


老兄那天看到你在前面怎样过湾我都看到了～不是你对手啦！！！

同感。。。。。。。。。

修真

ER6N骨架有裂纹-Fractures reported on Kawasaki ER6 frames
请查阅~~
http://www.google.com.my/imgres?imgurl=http://www.motorcyclenews.com/upload/196803/images/kawasakier6.jpg&imgrefurl=http://www.motorcyclenews.com/MCN/News/newsresults/mcn/2007/July/july16-22/jul2007fracturesreportedonkawasakier6frames/&h=600&w=800&sz=33&tbnid=_JAWNVw9HdiqQM::&tbnh=107&tbnw=143&prev=/images%3Fq%3Der6&usg=__OdKIChpFV1Q693U0ARFhFHD401M=&ei=he4SSs3XD4zqsgOF9qzdDQ&sa=X&oi=image_result&resnum=5&ct=image

[ 本帖最后由 修真 于 20-5-2009 02:16 AM 编辑 ]

kent26

老兄没有东西看的？？？？看不到

kelvinlowlcy354

原帖由 修真 于 20-5-2009 02:04 AM 发表
ER6N骨架有裂纹-Fractures reported on Kawasaki ER6 frames
请查阅~~
http://www.google.com.my/i ...

修真，你要说是这辆吗？

原帖由 kent26 于 20-5-2009 10:07 AM 发表
老兄没有东西看的？？？？看不到

你都还没回答我你们去泰国做什么？你熟悉那里的路吗？那里的motor零件店你懂吗？想过去那里找好料。

[ 本帖最后由 kelvinlowlcy354 于 20-5-2009 10:24 AM 编辑 ]

kent26

原帖由 kelvinlowlcy354 于 20-5-2009 10:23 AM 发表



修真，你要说是这辆吗？




你都还没回答我你们去泰国做什么？你熟悉那里的路吗？那里的motor零件店你懂吗？想过去那里找好料。

去泰国shopping，按摩，吃喝，摇头，还有儿童不宜的。我不会路的～跟大队跑

修真

这是一份报道，指出ER6N的骨架有裂纹




Fractures have been reported on the frames of Kawasaki ER6s


Fractures reported on Kawasaki ER6 frames

By Chris Newbigging -

General news

25 July 2007 09:30

If you’re a Kawasaki ER-6 owner, walk outside and check the frame for cracks.
A number of riders on the continent have experience the issue, but it has since emerged that a UK bike has suffered the same problem.

The problem lies with the engine mount on the right hand side (at the front of the tube that wraps around the cylinder), where a weld can split on the underside of the tube. The problem can be difficult to spot (ER6-F models will require the right hand side fairing to be removed), but tell tale signs include paint flaking off and rust forming on the bare metal.

MCN reader James Mear’s 2006 ER-6f has developed a crack on the engine mount. He told MCN: “I purchased a set of frame protectors, and when I was fitting the protectors I noticed a rust mark on the engine mounting weld. On further inspection I discovered it was cracked, it appears that the frame of the bike is wider than the engine and the engine bolt is twisting the bracket and welds as it is tightened to take up the gap.”

MCN contacted Kawasaki to find out if the issue is a danger to other ER-6 owners – this is its response.

“Kawasaki Motors UK values the feedback from MCN. In recent months there have been some reports regarding alleged problems with the frame on the ER-6n, primarily in mainland Europe. As a responsible manufacturer, Kawasaki has taken these reports very seriously. After careful investigation and testing, we were able to determine the problem was related to installation of aftermarket mushrooms. Should any action be required in the UK market, we will take the necessary action.”
• Has your ER-6 suffered frame problems? Contact MCN on 01733 468026.

回复讨论者：
Cracked frame

This frame issue has not been publicised much here in Australia. My 2006 ER-6N has cracked frame. It has a set of frame protectors supplied by my dealer. The crack is similar to the cracks appearing on the 2005 and 2006 European ER-6N’s. When I showed the cracked frame of my ER-6N to my dealer, the service supervisor had a look at the frame of another ER-6N which was being serviced. That ER-6N had no frame protectors or mushrooms but had cracked frame like my bike. What can you say about that Kawasaki? No frame protectors but with cracked frame. Kawasaki should come clean on this and accept their responsibility on this frame issue. As a responsible company, Kawasaki should not be blaming the frame protectors for their design and manufacturing faults.

修真

原帖由 kent26 于 20-5-2009 10:47 AM 发表

去泰国shopping，按摩，吃喝，摇头，还有儿童不宜的。我不会路的～跟大队跑

需要去到泰国那么远吃喝按摩摇头说拼还有儿童不宜咩？

kent26

不用怕～我的是2009你没有看清楚吗？
那是旧款式的

修真

很难讲的，你买时没有叫他们拆到完给你看了再组装回去咩？

[ 本帖最后由 修真 于 20-5-2009 11:44 AM 编辑 ]

nickyteo

下次有去金马伦磨轮胎,CALL 我.

鼻涕虫

看了你的头像觉得很痛。

看了黄色和白色的，还是觉得白色好看。

super_white

原帖由 修真 于 20-5-2009 11:05 AM 发表

需要去到泰国那么远吃喝按摩摇头说拼还有儿童不宜咩？

冰城近近的有吗？

pp3535

原帖由 kent26 于 20-5-2009 10:47 AM 发表 [url=http://cforum5.cari.com.my
去泰国shopping，按摩，吃喝，摇头，还有儿童不宜的。我不会路的～跟大队跑

dannok有很多。。

修真

原帖由 鼻涕虫 于 20-5-2009 12:06 PM 发表
看了你的头像觉得很痛。

看了黄色和白色的，还是觉得白色好看。

橙色的也不错

原帖由 super_white 于 20-5-2009 12:24 PM 发表


冰城近近的有吗？

儿童不宜，问那么多做莫？
死开！

super_white

原帖由 修真 于 20-5-2009 07:06 PM 发表

橙色的也不错

儿童不宜，问那么多做莫？
死开！

LIMPEK长大了。。。

kent26

原帖由 nickyteo 于 20-5-2009 11:47 AM 发表
下次有去金马伦磨轮胎,CALL 我.

没有问题～31号泰国要去吗？也是磨轮胎哟～